Edwards 1-1/2" Square Tube Bender Die for 10-Ton Tube & Pipe Bender Radius & Bend Angle:7" Radius 90° 45° Right)

45° Right)

Consistent Deburring

but works with the bellows supplied in almost all HEGNER models

your workflow stays efficient and your results improve

This cuts down on setup time and helps you produce the same accurate bend run after run

Edwards 1-1/2" Square Tube Bender Die for 10-Ton Tube & Pipe Bender Radius & Bend Angle:7" Radius 90° 45° Right)Edwards 1 1 2" Square Tube Bender Die for 10 Ton Tube & Pipe Bender The Edwards 1 1 2" Square Tube Bender Die fits the Edwards 10 Ton Bender for clean square tube bends up to 90 or 180. It runs off an Edwards Ironworker equipped with the PowerLink System. A brass follower supports the tube through the bend and helps the die hold up over time. Bends 1 1 2" square tube up to 90 or 180 Runs off the Edwards 10 Ton Bender with PowerLink Brass follower